Roper Washing Machine Error Codes - Meanings and Solutions
Roper washing machines are manufactured by Whirlpool and use a very similar diagnostic system. Understanding Roper washing machine error codes helps homeowners quickly identify common issues without unnecessary service calls.
Why Roper Washing Machine Error Codes Matter
Roper, Whirlpool, Maytag, and Amana all share the same VMW/F-code error system, meaning troubleshooting steps that apply to one brand generally apply to the others as well.
Common Roper Washing Machine Error Codes
F8 E1 – No Water / Long Fill. The machine is filling too slowly or not at all. Solution: Check the hoses and inlet valves for blockages or kinks.
F8 E3 – Overflow Condition. The water level is too high, usually from a valve that won't shut off. Solution: Professional inspection of the water inlet valve is recommended.
F8 E5 – Hot/Cold Hoses Swapped. The inlet hoses are connected to the wrong ports. Solution: Turn off the water and correct the hose connections.
F9 E1 – Long Drain. The washer takes too long to drain. Solution: Clean the pump filter and check the drain hose for kinks.
F5 E2 – Lid Lock Error. The lid cannot be detected as locked. Solution: Check for obstructions near the lid switch and latch mechanism.
F7 E1 – Motor Speed Error. The motor cannot reach the required cycle speed. Solution: Confirm shipping bolts have been removed and the load isn't overloaded.
Sud / Sd – Excess Suds. Detergent overuse has caused a suds lock. Solution: Reduce detergent and run a rinse cycle without soap.
UL – Unbalanced Load. The washer detects an uneven load during spin. Solution: Redistribute the laundry evenly and restart the cycle.
LOC / LC – Control Lock Active. This is not a fault; the control lock feature is simply engaged. Solution: Hold the designated button to release it.
When to Call a Professional
Fill, lid, and load-balance codes are usually manageable at home. Persistent overflow (F8 E3) or motor speed faults (F7 E1) typically indicate a failing valve or motor component and should be handled by a qualified technician.